Aim: The aim of the experiment is to test the effect temperature has on the activity of the enzyme rennin. Hypothesis: I believe the rate of reaction will speed up as the temperature increases until it reaches about ICC, which is the body temperature, where it will begin to slow down and stop reacting. I believe this will occur because enzymes have a temperature range at which they work best in and once the temperature goes out of this range the enzyme will stop working.
Introduction:Enzymes are made up of proteins which are produced within living cells and act as catalysts which speed up chemical reactions.
They are made up of long Haines of amino acids containing carbon, hydrogen, oxygen and nitrogen. Enzymes are structured to be unique to a few but often only one substrate therefore being specific to one type of reaction. A substrate is the molecule that an enzyme acts upon. An enzyme has an active site which is shaped for a specific shaped substrate.
The substrate and the enzyme bind together at the active site and form an enzyme- substrate complex. This then breaks down to form the products, releasing the enzyme. During the reaction the enzyme does not undergo change.
Most organisms can only survive within certain temperature ranges. For reactions to occur substances must collide with the correct orientation and necessary amount of energy, called the activation energy. The role of the enzyme is to lower the activation energy which therefore allows chemical reactions to take place inside organisms without the temperature having to be so high as well as speeding up the reaction. Every enzyme has a certain temperature range where it can work most efficiently with an optimal temperature at about 37. CO for most enzymes within the body. Once the temperature goes above the enzymes temperature range, the enzyme will egging to denature as intermolecular and intermolecular bonds begin to break as the kinetic energy intensifies as the temperature increases. Once the enzyme in denatured it cannot be reversed. Rennin is a protein digesting enzyme which is produced in the stomach of mammals such as cows. In the cows fourth stomach its function is to extend the amount of time the milk remains in the stomach by thickening it.
It is used in this experiment as it catalysts the conversion of the protein of milk called occasioning to produce the compound casein. The casein will curdle the milk making it lumpy. As rennin is an enzyme it will be specific to a certain temperature therefore the rate at which the milk goes lumpy will demonstrate the effect different temperatures will have on enzymes. Materials:-6 Test tubes-Full cream mil k-Stop watch-Junket powder-saucepan-Water- Thermometer-mall Measuring cup-2 x ml Measuring cups-Tea spoon-Ice subcommittees:1 . Set up apparatus.
Pour water into a saucepan and place on stove top. 2. Pour 5 ml of milk into six test tubes and keep in fridge. 3. Make enzyme mixture by measuring ml of water with the mall measuring cup and mixing in 1 level teaspoon of Junket powder and set aside. 4. Heat water in saucepan to ICC using a thermometer. Once the water in saucepan has reached the desired temperature turn off the stove. 5. Get two test tubes with the milk and place in sauce pan making sure they sit so no water can enter the test tubes. Wait for the milk to reach 30 co, using the thermometer. 6.
Once the temperature reached about ICC the speed of the reaction began to slow down. This because once the heat rises above the enzymes temperature range the shape of the enzyme will change consequently making it ineffective because its shape will not fit with the substrate. The results from the experiment support the hypothesis that the rate for the milk to solidify would speed up as the temperature got closer to ICC and would slow down and stop once it passed that temperature. In conducting the experiment I came across a few difficulties. One was keeping the temperature consistent.
When heating the water it would still continue to rise about one or two degrees once I had turned the stove off then after a few minutes if would begin to drop so I would have to turn the stove back on again. It was also difficult keeping the cooler temperatures consistent as well. I had to keep restocking with ice cubes but if I put too many in it would drop below the desired temperature. Another difficulty was measuring the exact amount of milk and enzyme mixture. Parallax error loud have made the measurements inaccurate because the view at which I looked upon the measuring cups could have varied each time.
The role of the test tube without the enzyme mixture was to insure that when the milk reached certain temperatures it did not clot without the enzyme. This was to rule out the possibility of temperature making the milk clot. An area to improve the reliability of the experiment would be to repeat the experiment more times. This would make the averaged result more accurate and by repeating the experiment any results that are very different to the rest of the results loud be easily noticed and disregarded as they do not follow the same trends. The accuracy could be improved by having more accurate measuring equipment.
Of measuring the amount of liquids a pipette could be used to have more precise measurements of the enzyme mixture and milk. The thermometer has a margin of error of В±0. 5 degrees therefore more exact equipment would make the results more reliable. The results from the experiment are valid as they are similar to the excepted value that the rennin enzymes optimal temperature is ICC and follows the trend that the rate of reaction will speed up until it reaches that temperature then start to low down once it has passed it. To further show enzymes being denatured higher temperatures could be used in the experiment.
The optimal temperature at which an enzyme works within the body is ICC. This is the temperature the enzymes work most efficiently at. If the temperature rises above ICC the activity level decrease because the enzyme will become less efficient as the heat will begin to start changing the shape of the enzyme and as the temperature increases the enzyme will by destroyed by the heat. As the temperature rises the intermolecular and intermolecular bonds begin to break causing the active site to hanged shape and therefore the active site is no longer the correct shape for the occasioning substrate.
This is a denatured substrate and once denatured it cannot be reversed. The active site on an enzyme is where the enzyme combines with a substrate. The characteristics of the amino acids at the active site play a large role in whether the substrate molecule with fit or by attracted to the enzyme. Amino acids at the active site break the bonds of the substrate molecule to form the products. Other amino acids at the active site work by attracting specific areas of the substrate molecule so hat it is held in the correct position so the reaction at the active site can carry on.
Enzyme specificity refers to enzymes limitations to only react with on type of substrate. This can be demonstrated through the lock and key model which illustrates the substrate acting upon the enzyme. Once they combine they form an enzyme-substrate complex. This is where the amino acids of the enzyme break bonds in the substrate to form products. The enzyme is then freed and is not changed during the reaction. The controls of this experiment were the amount and concentration of the enzyme suture and the amount of milk used.
Keeping these the same throughout the experiment was important because my research showed that the concentration of the enzyme would affect the results of my experiment. In order to eliminate the possibility of my results being affected by something other than temperature I had to keep the concentration the same. Pepsin is an enzyme in the human body which is found in the stomach. Its role in the body is to break down proteins from meat, dairy products, seeds and eggs, into shorter chains of amino acids. These are then absorbed into the blood stream or Rosen down further.
Within the lining of the stomach, glands produce and store an inactive protein called possession . When it is combined wit n hydrochloric acid it converts to an active enzyme, pepsin. The pepsin is most effective in pH levels of 1. 5-2. 5 though can still work up to about pH 6 and is ineffective when gastric acids have been neutralizes. The temperature at which it is efficient ranges between 30 co end 40 co but can work at temperature between 15 co and 48 co. Conclusion: The results of this experiment show that temperature affects the rate at which the enzyme rennin works.
Cite this Biology: Experiment- The Effect of Temperature
Biology: Experiment- The Effect of Temperature. (2017, Oct 17). Retrieved from https://graduateway.com/biology-experiment-the-effect-of-temperature/