Diesel Engine Parts Essay
1 - Diesel Engine Parts Essay introduction. CYLINDER BLOCK- The engine block is the linchpin of vehicles which run on internal combustion, providing the powerhouse for the vehicle. EX: A General Motors in-line, 6-cylinder block- the entire unit is a one-piece casting of alloy cast iron. Transverse members provide rigidity and strength, ensuring alignment of the bores and bearings under all loads. Function- In the bore of cylinder the fresh charge of air-fuel mixture is ignited, compressed by piston and expanded to give power to piston. 2.
CYLINDER HEAD- It closes in the top of the cylinder, forming the combustion chamber. The head can also be a place to mount the valves, spark plugs, and fuel injectors. EX: Overhead Cam- valve train configurations place the engine camshaft within the cylinder heads, above the combustion chambers, and drive the valves or lifters in a more direct manner compared to overhead valves (OHV) and pushrods. Function-It carries inlet and exhaust valve. Fresh charge is admitted through inlet valve and burnt gases are exhausted from exhaust valve.
More Essay Examples on Diesel engine Rubric
In case of petrol engine, a spark plug and in case of diesel engine, an injector is also mounted on cylinder head. 3. CONNECTING ROD- The load on the piston due to combustion of fuel in the combustion chamber is transmitted to crankshaft through the connecting rod. EX: Compound Rods- Many-cylinder multi-bank engines such as a V12 layout have little space available for many connecting rod journals on a limited length of crankshaft. Function-It changes the reciprocating motion of piston into rotary motion at crankshaft.
This way connecting rod transmits the power produced at piston to crankshaft. 4. SPARK PLUG- A device inserted in the head of an internal-combustion engine cylinder that ignites the fuel mixture by means of an electric spark. EX: Surface-discharge spark plug- A piston engine has a part of the combustion chamber that is always out of reach of the piston; and this zone is where the conventional spark plug is located. Function- This device is used in petrol engine only and ignite the charge of fuel for combustion. . CARBURETTOR- is a device that blends air and fuel for an internal combustion engine. EX: Accelerator pump- Liquid gasoline, being denser than air, is slower than air to react to a force applied to it. When the throttle is rapidly opened, airflow through the carburetor increases immediately, faster than the fuel flow rate can increase. Function-It converts petrol in fine spray and mixes with air in proper ratio as per requirement of the engine.